10 Minute BidsShingle roofing takeoffs from plans
in Spokane and eastern Washington.
Upload the plan set for a house in Spokane, Spokane Valley, Liberty Lake and Deer Park. We build it in 3D and measure the shingle roofing off the model, with Spokane & eastern Washington's design numbers in view. You spend about 10 minutes checking it against your plans, and it's ready to price and send.
Priced per plan setShingle roofing bid, 3D model includedShingle roofing takeoff, 3D model included
Launch offer: the first 100 sign-ups get their first trade bid for $10.
Read the video transcript
Need a shingle roof bid off a set of plans? Skip the takeoff. Upload the plans. Within minutes we've read the roof plan and elevations, and you see your price. Shingles in 3D: 24 roof planes, 4,695 sq ft, from 2:12 to 10:12. 57 squares to order, waste figured from the roof's own cuts.
Starter on every eave, 181 ft of ridge cap, 162 ft of valley, step and wall flashing. All 4 pipe boots + the bath fan vent, marked right where they come through. Low-slope sections get extra underlayment; vents checked against code. Bundles, underlayment, flashings and vents go into a draft bid you can price and send.
Plus a supplier order sheet: save it as a PDF and email it. Every bundle and roll. Upload your plans at 10minutebids.com
Example house · address hidden
The local numbers behind a shingle roofing bid.
What Spokane and eastern Washington builds to, and what it means for the takeoff.
| Where | Snow load | Design wind speed | Ice barrier required |
|---|---|---|---|
| Spokane County | 39 psf (ground) | 110 mph | Yes |
| Spokane | 39 psf (ground) | 110 mph | Yes |
- Snow load: 39 psf (ground) (Spokane County). The trusses, rafters and roof sheathing on your plans are designed for the snow load; if the truss notes show a different number, ask before you bid.
- Design wind speed: 110 mph (Spokane County). Shingles go on with the maker's nailing for the wind speed, and high-wind nailing changes the nail count.
- Ice barrier required (Spokane County). Budget an ice-and-water membrane on every eave, from the edge to at least 24 inches inside the exterior wall line.
Sources: Spokane County: Spokane County Building Dept · Spokane: Spokane Municipal Code 17F.040.105 Design Criteria. Read 2026-09-28. Every number is as the jurisdiction publishes it (its design criteria for houses, IRC Table R301.2(1)); a dash means it isn't published. Your lot can differ with elevation and exposure, so confirm it with the building department before you order.
Squares, edges and flashing, counted.
Your takeoff is built from the model, not a scale ruler. Here's what it covers, with the numbers from our example house.
- Squares by plane and pitch, with waste figured from the cuts
- Starter along every eave, hip and ridge cap
- Valleys, step flashing and headwall flashing
- Underlayment, with ice and water shield on low slopes
- A supplier order sheet to save as a PDF and email to your supplier. See a sample
Every trade in Spokane and eastern Washington.
Add another trade to the same order: each one after the first in the same order is half price. All of Spokane & eastern Washington · Every area
Shingle roofing takeoffs in Spokane & eastern Washington
Do you do shingle roofing takeoffs for houses in Spokane?
Yes. Upload the plan set for a house anywhere in Spokane and eastern Washington (Spokane, Spokane Valley, Liberty Lake, Deer Park, Cheney and Colville), or anywhere else. Nothing has to be built yet: we measure the house on the plans.
What design numbers apply in Spokane?
Spokane publishes snow load: 39 psf (ground); design wind speed: 110 mph; ice barrier required: yes. The design on your plans should match them, and the takeoff follows your plans. Elevation and exposure can change them for your lot, so confirm with the building department.
Does a takeoff cost more in Spokane & eastern Washington?
No. The price is the same everywhere, and you see it before you pay. The 3D model is included, and each trade after the first in the same order is half price.
Is this an exact price?
No. It's an estimate built from your plans. Plans don't show the roof as it really is: rotten decking or old layers under a re-roof, or crickets and saddles that aren't drawn. Anything built differently from the drawings won't be in the bid. We recommend a site visit to confirm measurements and conditions before you sign a contract or order materials.
Have a plan set?
Send it in.
Any house in Spokane and eastern Washington. The 3D model and the takeoff come off your own plans.